ATON HDR44 Manual Del Usuario página 20

Ocultar thumbs Ver también para HDR44:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Front Panel IR Receiver Connection
Connect an ATON IR Receiver to R44WP front panel IR Input connector as shown in Figure 3-17.
HD Video Display
Figure 3-17: R44WP Front Panel IR IN Connection
AIR1 IR Receiver
GND (Black)
+12V (Red)
Figure 3-18: R44WP Rear Panel IR IN Connection
Run a Cat-5 wire from the R44WP to the IR Receiver location. Next, cut off the 3.5mm plug of
the IR Receiver and strip back the wire jacket to expose the conductor wires. Then, strip the
ends of the conductors and twist the bare ends of the IR Receiver wires to the appropriate con-
ductors of the Cat-5 wire as shown in Figure 3-18. Finally, connect the correct Cat-5 conductors
to the screw terminals of the R44WP.
20
HDR44 4x4 High Defi nition Video Router
IR Receiver
3.5mm mono
connector
GND (Brown)
+12V (White/Green)
IR (White)
IR (Blue/White)
SPDIF
SPDIF
Y
L
P
B
R
P
R
IR IN
IR OUT
OUT
R44WP
R44WP
Cat-5 Cable
GND
+12VDC
IR IN
©2008 • All rights reserved.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido