Control Loop; Component Video Output - ATON HDR44 Manual Del Usuario

CONTROL LOOP

For system expansion, connect the included Cat-5 patch cable from the HDR44's CONTROL
LOOP port to one additional HDR44's CONTROL LOOP port. This will allow IR signals to pass
from the expansion chassis through the fi rst chassis so that the source equipment can be
controlled.
Component Video Outputs
Use high quality component video cables to loop connections from the main HDR44 to the
expansion unit:
Chassis #2
Figure 3-20: Component Video Loop Connection
22
HDR44 4x4 High Defi nition Video Router
Chassis #1
CONTROL LOOP
RJ45 Cable (Included)
CONTROL LOOP
Chassis #2
FIgure 3-19: CONTROL LOOP
Chassis #1
Component
Video Cables
©2008 • All rights reserved.