Display Symbols:
User 1: Appears when the monitor is operated by User 1.
User 2: Appears when the monitor is operated by User 2.
PM
AVG. 3
Weak Battery Symbol: Appears when batteries should be
replaced.
Pulse Symbol: Shows the heart rate per minute.
U P
ROTATE
Wrist Positioning Guide: See page 14 for more information.
LEFT
RIGHT
N
D O W
AVG. 3
PM
Irregular Heartbeat Detector: See page 24 for more
information.
Memory Average: Displays average of last 3 readings.
Risk Category Index: See page 23 for more information.
If
and any of the following letters and numbers appear in the area that
(No Symbol)
systolic pressure should be displayed or the wrist icon appears, an error has
ROTATE
occured with your reading. See Troubleshooting section of this manual for more
LEFT
M
START
information.
STOP
RIGHT
N
Measurement Error: Wrap the cuff correctly and keep wrist
steady during measurement. Measure again.
Air Circuit Abnormality: Measure again.
Pressure Exceeding 300 mmHg: Switch the unit off to clear,
then measure again.
Error Determining Measurement Data: Measure again.
AVG. 3
PM
Component Error: Measure again.
System Error: Measure again.
U P
Wrist Is Not In The Ideal Position: Measure again. Once
ROTATE
LEFT
the wrist positioning sensor guides your wrist to your ideal
RIGHT
N
D O W
location, keep arm still until measurement is completed.
11
INSTALLING BATTERIES
1. The battery cover is located along
the side of the monitor. Remove
battery cover by pressing down
and pulling away from the
monitor.
2. Install batteries according to
the polarity indications inside
the compartment (as shown
in figure 2). Battery Type: 2
Alkaline LR03 (AAA) size
3. Insert the other battery,
according to the polarity
indications inside the
compartment (as shown in
figure 3).
4. Replace the cover by inserting
it back into place.
1.
2.
3.
4.
12