Making Coffee With A Preset Time - Beem MD-286BT Instrucciones De Uso

EN
Preparation
PLEASE NOTE!
• The device should only be used if it has been correctly assembled! Before each use, check
whether the fi lter holder and the permanent fi lter are inserted correctly and whether the
water tank is fi lled correctly!
• Do not operate the device without water. If this does happen, the device switches off
automatically. In this case, allow the device to cool down before water is poured in and the
device is used again.
• Never use the device without a suitable jug below the coffee outlet.
1. Prepare the coffee machine (see the "Handling and Operation" chapter).
We recommend always making at least 4 cups of coffee as the brewing time when making
just 2 cups, for example, is very short for making coffee with real fl avour and this can have
an adverse effect on how the coffee tastes.
2. If you wish, activate the "Added Flavour" function BEFORE starting the brewing process (see
the "Handling and Operation" chapter - "Added Flavour Function").
3. Touch the ON/OFF fi eld (10) to start the brewing process. The red operating lamp (12)
appears on the display (8). Hot water is poured over the coffee powder to brew it.
The red operating lamp goes out after the end of the brewing process. The thermal jug (6) can
then be removed.
To end the brewing process prematurely, touch the ON/OFF fi eld again. The red operating
lamp goes out and the brewing process is aborted.

Making Coffee with a Preset Time

To make coffee with a preset time, the clock needs to be set (see the "Handling and Opera-
tion" chapter – "Setting the Time").
1. Prepare the coffee machine (see the "Handling and Operation" chapter).
2. If you wish, activate the "Added Flavour" function BEFORE activating the timer (see the "Han-
dling and Operation" chapter - "Added Flavour Function").
3. Touch the PROG fi eld (17) twice. The display shows TIMER (16) and the preset time 12:00
(13).
4. Set the hours by turning the dial (3).
5. Wait until the minutes display fl ashes and set it by turning the dial.
6. Wait a few seconds or touch the PROG fi eld again. The blue timer control lamp (15) lights up.
Once the preset time has been reached, the brewing process starts automatically. The blue control
lamp goes out on the display and the red operating lamp (12) lights up.The red operating lamp
goes out after the end of the brewing process.
09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 22 09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 22
22
26.06.2020 13:27:23 26.06.2020 13:27:23