Set-Up And Connection; Handling And Operation; Setting The Time - Beem MD-286BT Instrucciones De Uso

EN

Set-Up and Connection

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed. The plug socket must
also be readily accessible after connection so that the connection to the mains can quickly
be isolated. The mains voltage must match the technical data of the device.
• Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
1. Fully unwind the connecting cable.
2. Place the device on the kitchen unit or another dry, solid, fl at, heat-resistant and splash-proof
work surface. Ensure there is suffi cient clear space on all sides (at least 20 cm to the sides and
30 cm above).
3. Insert the mains plug into a properly installed plug socket. The plug socket must be readily
accessible so that the connection to the mains can quickly be isolated.

Handling and Operation

PLEASE NOTE!
• Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
• Never overfi ll the permanent fi lter.

Setting the Time

As soon as the mains plug is plugged into a plug socket, the display lighting turns on and the time
12:00 (13) is shown on the display (8). The clock has a 24-hour time format.
1. Touch the fi eld PROG (17). UHRZEIT (time) (11) appears on the display.
2. Set the hours by turning the dial (3).
3. Wait until the minutes display fl ashes and set the minutes by turning the dial.
After around 10 seconds, UHRZEIT (time) disappears on the display. The time is now set.
The time is saved until a new time is set or the device has been disconnected from the
power supply.
09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 20 09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 20
20
26.06.2020 13:27:23 26.06.2020 13:27:23