Filling The Water Tank - Beem MD-286BT Instrucciones De Uso

21

Filling the Water Tank

1. Open the lid (1).
2. Pour the quantity of water required for the number of cups you want (maximum 8 cups) into
the water tank (7).
3. Close the lid. You must hear and feel it engage.
All of the water in the water tank is always used.
Pouring In Coffee Powder
1. Open the lid (1).
2. Insert the fi lter holder into the fi lter compartment (2).
3. Insert the permanent fi lter or a fi lter paper (size 1x4) into the fi lter holder.
4. Add the quantity of coffee powder you want to the fi lter directly using the measuring spoon
which is supplied with the device or another suitable spoon. We recommend one level spoon-
ful for each 125 ml cup.
5. Flip the lid shut. You must hear and feel it engage.
"Added Flavour" Function
If you like your coffee a little stronger, you can switch on the "Added Flavour" function. Note here
that the fl ow time will be extended as a result.
Touch the fi eld PROG (17) for approx. 3 seconds until
The "Added Flavour" function remains selected and is used each time you make coffee until the
PROG button is pressed again for approx. 3 seconds.
function is switched off.
Drip Stop
The device has a drip stop which prevents water from dripping out of the fi lter compartment (2)
when the thermal jug (6) is removed from the device.
When the device is in operation, the fi lter compartment must be closed and the thermal jug with
the lid placed on it must be placed beneath the fi lter compartment. The lid of the thermal jug
pushes the drip stop upwards and the coffee can fl ow from the permanent fi lter through the lid
into the thermal jug.
During the brewing process, the thermal jug must not be removed from the main unit for
longer than 30 seconds as otherwise the permanent fi lter could overfl ow.
09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 21 09886_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 21
(14) is shown on the display (8).
then goes out on the display and the
EN
26.06.2020 13:27:23 26.06.2020 13:27:23