Suzuki 57100-0482 Serie Instrucciones Para El Montaje página 7

10.Pass the grip heater lead wire
between the switch box and the
front brake master cylinder
holder. Align the white tape part
of the grip heater lead wire with
the contact surface of the
switch box and fix it by using a
Clamp 6.
CAUTION
Fix the grip heater lead wire
securely by using a clamp so
that no tension should be felt
in the throttle grip lead wire
when operating the throttle.
NOTE: Cut off the excess clamp.
Installation of Grip Heater (L)
1. Loosen the screw of balancer
with a + driver several turns
and pull the handlebar balancer
out of the handlebar.
NOTE: Loosen the screw only
enough to remove the
handlebar balancer. Oth-
erwise, the handlebar bal-
ancer may disassemble
and some
may remain in the handle-
bar.
components
GENUINE SUZUKI ACCESSORIES
Handlebar balancer Handlebar balancer
Screw Screw
7/17
Grip heater Grip heater
lead wire lead wire