geberit EFP 2 Instrucciones De Servicio página 14

Special safety notes
14
Operating instructions EFP 2
DANGER
Fatal electric shock hazard
` Do not operate the tool in wet and damp surroundings
` Before using, always check the tool, mains cable and mains
connector for damage and ensure that the tool is functioning
` Avoid bodily contact with grounded surfaces
` Do not touch damaged mains cables or mains connectors. Have
them replaced immediately by an authorised specialist
` Never alter a mains connector in any way. It must always fit easily
into the socket
` Do not use adapters
` Do not use the mains cable for purposes for which it was not
intended, to carry tools or hang them up, or to pull out the connector
` Protect the mains cable from heat, oil, acids, sharp edges and
moving tool parts
` When working outside, only use extension cables that are approved
for outdoor use
` Unplug the mains connector before starting any maintenance work
on the tool
WARNING
Risk of injury from incorrect handling
` Only plug in the mains connector when the tool is switched off
` Unplug the mains connector after use
` Always route the mains cable from the back of the tool and do not
pull it over sharp edges
` Hold the tool with both hands
Risk of injury by switching on inadvertently
` Do not carry the tool with your finger on the switch
` Switch the tool off in the event of a power failure
` Do not connect the tool to the power supply when switched on
` Unplug the mains connector before changing accessories and
putting the tool away
` Unplug the mains connector before starting any maintenance work
on the tool
Danger of crushing by moving parts
` Do not hold the tool in the area of the pressing jaws
` Do not hold any parts of your body or other objects in between the
pressing jaws
` Do not hold the jaw lever with your hands during the pressing
operation