Adjusting The Edger's Cutting Depth - Husqvarna EA850 Manual De Instrucciones

E
Assembly of the blade guard and
blade
First place the blade guard
(A) on the angle gear (B),
see the diagram. There is a
slot on the guard that fits
to a guide flange on the
gear housing. Fit the
clamp (C) on the opposite
side against the guard, on
the angle gear. The clamp
also has a slot that fits to
the gear's guide flange.
Insert the bolt (D) and the
locking handle (E) and
pull together the clamp
and guard. See the
diagram. Do not tighten
too hard. It should be
possible for the blade
guard to rotate on the gear
housing. Rotate the guard
on the gear housing until
the hole on the gear
housing for the locking
pin (F) is visible. Fit the
drive disc (G) on the gear
housing axle and rotate the
drive disc until the hole in
the drive disc aligns with
the hole in the gear
housing. Insert the locking
pin through the hole in
the gear housing and into
the hole in the drive disc.
Fit the blade (H), washer
(J) and tighten the bolt
(K). The bolt has a left-
hand thread. Tighten
securely.
NOTE! Do not forget to remove the locking pin before using
the machine.
!
WARNING!
Under no circumstances may the edge
cutter blade be used without the blade
guard fitted.
44
ASSEMBLY
D
E
A
C
B
F
G
H
J
K

Adjusting the edger's cutting depth

The cutting depth should be
adjusted before starting work.
Loosen the locking handle (A)
and rotate the guard (B) by
moving the locking handle
backwards or forwards. If the
locking handle is moved
forwards (from the machine)
the cutting depth is increased.
If the locking handle is moved
backwards (towards the
machine) the cutting depth is
reduced.
!
WARNING!
Always bear the machine on the right
side of the body. Always wear protective
glasses, long trousers and heavy-duty
shoes when using the machine. Observe
your surroundings, ensure people and
animals do not come in the immediate
vicinity or can be hit by thrown objects.
Apply full throttle before the blade starts
to work on the soil.