Fitting The Cover Panel; Installing The Stainless Steel Panel; Installing The Drive Unit - BADU JET Turbo Pro Traducción De Las Instrucciones Para El Manejo Originales

5.3.3

Fitting the cover panel

1. Clip the cover panel (52) labelled "Top" into the plastic panel
(5).
5.3.4

Installing the stainless steel panel

1. Remove two fastening screws (6 x 22) from the plastic panel
(5).
2. Align the stainless steel panel (55) to the plastic panel (5).
3. Tighten the 12 tapping screws 6 x 22 (56) with a torque of 6
Nm.
Fig. 14
5.3.5

Installing the drive unit

1. Pull the O-ring (36) onto the propeller unit (3).
2. Insert the propeller unit (3) centrally with the orientation pin in
6 o'clock position on the housing centring/flange centring.
3. Tighten 10 hexagon socket head tapping screws (7x48 (37))
with a torque of 8 Nm.
08|2020
Installation
EN 29