Installing The Nozzle Unit - BADU JET Turbo Pro Traducción De Las Instrucciones Para El Manejo Originales

Installation
5.3.2

Installing the nozzle unit

1. Insert the nozzle unit (4) with its 3 fastening domes into the
cylindrical depression of the housing centring/flange centring.
2. Tighten the three tapping screws (6x40 (46)) with a torque of
6 Nm.
Fig. 13
NOTICE
Appropriate adapters (45) must be installed between the housing
and the nozzle unit (4) for a pool wall thickness from 3.5 mm up to
max. 27 mm.
The adapter height must be chosen so that the round panel (52)
has no gap bigger than 8 mm from the maximally swivelled ball
nozzle (42) in the installed state.
The following order kits must be used above a wall thickness of
7 mm:
Wall thickness
(mm)
0 to 3.5
above 3.5 to 7
above 7 to 11.5
above 11.5 to 14
above 14 to 17.5
above 17.5 to 21
above 21 to 24
above 24 to 27
28 EN
Screw length
Adapter type
(mm)
- 40
Washer 3.5 40
Washer 7 50
C 50
D 50
E 60
F 60
G 60
Order kit
-
-
1
1
1
2
2
2
08|2020