Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Click on the CHART button to set the chart preferences.
Disable or Enable the desired charts.
Configure Communications
Click on CONFIG then on COMMUNICATIONS
If you will be using the USB cable click on "Use Com Port"
If you will be using the Ethernet cable click on "Use Network
Communications"
NOTE: If using Network Communications refer to the Megger PQ
Software manual to setup the IP address in the analyzer.
Click OK.
COMPLETE
MPQ1000
GETTING STARTED
6
Part No. 85635 Rev. 1 Dec 2016
Publicidad
Tabla de contenido
