Ceiling Space; Lowest Position During Tilting; Footrest; Fixation Straps - Enraf Nonius Manumed Tilt Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
4.5

Ceiling space

!
Take care that the tilt table is used only in
treatment rooms with sufficient ceiling space.
Ceiling hight minimal 2,30 meter.
4.6

Lowest position during tilting

!
Ensure that the height of the table is set to the
lowest position before tilting is commenced. This will
give maximum stability
4.7

Footrest

!
Never commence tilting before the two section
footrest is placed in the correct upwards position.
Adjust the angle of the footrests only if the table is
set in the horizontal position.
4.8

Fixation straps

!
Never commence tilting before the patient is
properly secured to the table top. For this purpose
special knee and chest fixation straps should be
used (order number 3445.046, 3445.015 or
3445.024).
The fixation straps must be fastened to the side rails
which are located at either side of the table top.
Check the durability of the fixation straps before
every use, replace them immediately if they are
demaged.
4.9

Mains cable

!
A damaged mains cable can cause life threatening situations. To prevent this, comply with the
following rules.
Install the mains cable in such a way that danger for tripping is unlikely.
Ensure that the mains cable can not get entangled in the moving parts of the table.
The mains cable should only be removed from the electricity supply by pulling the plug away from
the socket. Never pull the mains cable itself.
Remove the mains cable from the supply first, before moving the table.
If the mains cable is damaged, put he table out of operation immediately by pulling the plug from the
supply. Call your local distributor for service.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido