ELICA METEORITE ISLAND Montaje Y Modo De Empleo página 42

Operation
For certain models, a remote control is available as accessory
kit, by which you can control the main functions of the hood.
Check with your authorised dealer or technical assistance
centre the compatibility/suitability of your model.
Control panel with 7 buttons
To select the functions of the hood you simply touch the
controls.
Automatic operation (sensor), connection
®
with SNAP
Button ON/OFF lighting
Press briefly to switch on or off the lighting of
the hob.
Press and hold to adjust the tonality of the
light (only certain models).
Button for intensive speed (suction power)
selection – it lasts 5 minutes then it returns
to medium speed (suction power) or it
switches off if the delayed shutdown of the
hood is activated (only with remote control).
The button flashes in both cases to indicate
speed timing.
Button for high speed (suction power)
selection.
The button flashes if the delayed shutdown
of the hood is activated (only with remote
control).
Button for medium speed (suction power)
selection
The button flashes if the delayed shutdown
of the hood is activated (only with remote
control).
Button for low speed (suction power)
selection – when flashing, it indicates that
you must wash the grease filter.
The button flashes if the delayed shutdown
of the hood is activated (only with remote
control).
Button OFF motor (stand by)
Indicators of Filter Saturation
At regular time intervals, the hood signals the need to perform
filter maintenance.
Button on with steady light: perform grease filter
maintenance.
Button
maintenance.
Note: Filter saturation signal is visible within the first
minute after switching off the hood; within this time, the
reset of saturation indicators must be performed.
Reset of filter saturation indicators:
Press and hold the button
Activation of saturation indicator activated charcoal
filter
Note: this operation must be performed with the hood off.
This indicator is normally deactivated; press and hold the
button
up with steady light.
To deactivate the function, press and hold the button
: the button lights up flashing.
Automatic operation (sensor), connection with SNAP
Attention! The proper operation of the hood will depend on
the 'Setting of parameters for Automatic Operation' (see
dedicated section)
Automatic operation (sensor)
Press the button
in white).
The hood will switch on at the most suitable speed based on
the cooking fumes detected by the sensor on the hood.
Automatic operation of the hood with SNAP
Press the button
orange) to indicate that the hood can operate automatically
®
with the SNAP
®
Note: SNAP is an auxiliary suction unit that can operate
together with the hood. For further information, please consult
the manual supplied with SNAP
Automatic operation of the hood with the Elica hob
Operation of the hood will also depend on use of the Elica
hob.
Press the button
to indicate that the hood can automatically operate with the
Elica hob; thus, hood operation will also depend on use of the
Elica hob.
Note: Automatic operation with the hob is possible only with
specific cooking hobs; for further details, please contact the
42
flashing: perform activated charcoal filter
to activate the function: the button lights
.(the central LED
.(the LEDs
®
.(the LEDs light up in white)
®
lights up
®
light up in