ELICA METEORITE ISLAND Montaje Y Modo De Empleo página 43

authorised dealer or technical assistance centre.
Automatic operation of the hood with SNAP
hob
Press the button
orange) to indicate that the hood can operate automatically
with the hob and the SNAP
Setting of parameters for Automatic Operation
Note: All calibration, selection, setting and logical
connection operations described below can be performed
with the hood off (OFF).
The adjustment of parameters is regularly done
automatically every time the hood is reconnected to the
mains (e.g. with the first installation or after a blackout) or
manually.
Manual setting
To be performed when you notice unsatisfactory
functioning of the Automatic operation, and is done when
normal environmental conditions persist in the kitchen.
Manual setting includes:
• Hood calibration
• Selection of hob (gas, induction, or electric)
• Logical connection between the hood and SNAP
you have SNAP
Hood calibration
Press and hold the button
flash to indicate initiation of calibration; the process
will last for approximately 5 minutes.
Selection of the hob (gas , induction, or electric)
Press and hold simultaneously the buttons
and : buttons
start flashing for 5 seconds.
Within this timeframe, press:
button in case of gas hob
button in case of electric hob
button in case of induction hob
The preselected button remains lit to indicate the
selection was performed, after 10 seconds the
button flashes briefly to indicate that the performed
selection was recorded.
®
.(the LEDs light up in
®
®
).
, all button LEDs
, and
Logical connection between the hood and SNAP
you possess a SNAP
and Elica
Control panel with 6 buttons
®
(if
Filter Saturation Indicators
At regular intervals the hood signals the need to perform filter
maintenance.
Button
grease filters.
Button
on the activated charcoal filter
Note: The filter saturation indicator is visible within the
first minute after the hood switching off; the reset of
43
®
).
Connection between the hood and SNAP
automatic. No other setting has to be performed.
Automatic operation (sensor) e
connection with SNAP
Button ON/OFF lighting
Press briefly to turn on or off the hob
lighting.
Press and hold to adjust the tonality
of light.
Button to select high speed
(suction power):
- first touch
Button to select intensive speed
(suction power):
- second touch
Intensive speed (suction power) has
a duration of 5 minutes, then the
hood returns to medium speed
(suction power); the button flashes.
Note: pressing again the hood goes
back to high speed (suction power).
Button to select medium speed
(suction power):-
Button to select low speed (suction
power):- when flashing, it indicates
you must wash the grease filter.
Button OFF motor (stand by)
on continuously: perform maintenance of
on with flashing light: perform maintenance
®
(if
®
is
®