Outdoor Unit - Acson international A5WMY10KR Manual De Operación

01_EN_3P257186-2A.fm Page 5 Saturday, October 31, 2009 2:19 PM

■ Outdoor Unit

• Appearance of the outdoor unit may differ from some models.
20
■Indoor Unit
1. Air filter
2. Titanium apatite photocatalytic
air-purifying filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. Display
8. Air outlet
9. Flap (horizontal blade): (page 11.)
10. Louvers (vertical blades):
• The louvers are inside of the air outlet.
(page 12.)
11. Model name plate
■Outdoor Unit
16. Air inlet (back and side)
17. Refrigerant piping and inter-unit wiring
18. Drain hose
19. Earth terminal:
• It is inside of this cover.
16 21
12. Indoor unit ON/OFF switch:
• Press this switch once to start operation.
Press once again to stop it.
• The operation mode refers to the following
table.
Mode
AUTO
• This switch is useful when the remote
controller is missing.
13. OPERATION lamp (green)
14. TIMER lamp (yellow): (page 16.)
15. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a beep sound.
• Operation start .......... beep-beep
• Settings changed....... beep
• Operation stop ........... long beep
20. Air outlet
21. Outdoor temperature sensor (back)
22. Model name plate
17
19
22
18
Temperature
Airflow rate
setting
25°C AUTO
5