Cv Table For Dcc - Marklin Digital 60978 Manual Del Usario

CV
Explanation
1 Main address
2 PoM Minimum speed (Vmin)
3 PoM Acceleration delay (AV)
4 PoM Braking delay (BV)
5 PoM Maximum speed (Vmax)
Automatic Calibration
7
Hersteller Versionsnummer (Softwareversion)
Manufacturer identification / ID
8
Decoder reset (default or factory setting)
13 PoM Functions F1 - F8 with an alternative track signal
14 PoM Functions FL, F9 - F15 with an alternative track signal
17 Expanded address, higher value byte
18 Expanded address, lower value byte
PoM ("Programming on Main") must be supported by the locomotive controller / central controller.

CV Table for DCC

Values Default
3
1 - 127
0 - 255 4
0 - 255 12
0 - 255 12
0 - 255 180
–
131
8
60978=0
0 - 255
60979=0
0 - 255 1
192
192 - 231
0 - 255 128
Notes
Short address 1 - 127
If CV 29 / Bit 5 = 0
Value must be lower than Wert muss
Vmax, CV 5. (see CV 67)
CV value multiplied by 0.9 gives the time
from being stopped to maximum speed.
CV value multiplied by 0.9 gives the time
from maximum speed to being stopped.
Speed at the highest speed level.
Value must be higher than Vmin, CV 2.(see
also CV 94)
Enter Value 77. Value 77 is not stored
continuously.
Read only
Value cannot be read
0 = Func. MM or analog off
1 = Func. MM or analog on
[ F8 F7 F6 F5 F4 F3 F2 F1 ]
0 = Func. MM or analog off
1 = Func. MM or analog on
[ F15 F14 F13 F12 F11 F10 F9 FL ]
Long address 1 - 10239 (128)
If CV 29 / Bit 5 = 1
45