Frigidaire FRSS2323AS Uso Y Cuidado página 27

CONCERN
DISPENSER (Ice & Water) (Continued)
Ice dispenser is
jammed.
Dispenser will not
dispense water.
Water has an
odd taste and/
or odor.
Water pressure
is extremely
low.
Water not cold
enough.
CAUSE
• Ice has melted and
frozen around auger
due to infrequent
use, temperature
fluctuations, and/or
power outages.
• Ice cubes are jammed
between ice maker and
back of ice container.
• Water filter not
seated properly.
• Water filter is clogged.
• Household water line
valve is not open.
• Water has not been
dispensed for an ex-
tended period of time.
• Unit not properly
connected to cold
water line.
• Cut-off and cut-on
pressures are too low
(well systems only).
• Reverse osmosis system
is in regenerative phase.
• As warmer tap water
goes through the filter
and enters the water
tank the chilled water
is pushed through to
the dispenser. Once the
chilled water is used up
it will take several hours
to bring the freshly
replaced water to a
cooler temperature.
• Some models are de-
signed without a wa-
ter tank, these water
dispensing systems
are not designed to
chill water.
TROUBLESHOOTING
• Remove ice container, thaw, and emp-
ty the contents. Clean container, wipe
dry, and replace in proper position.
When new ice is made, dispenser
should operate. See Cleaning the Ice
Storage Bin in the AUTOMATIC ICE
AND WATER DISPENSER section.
• Remove ice cubes that are jamming
the dispenser.
• Remove and reinstall the water filter.
Be sure to push the filter firmly so that
you hear it lock solidly into position.
• Replace filter cartridge. Be sure to
remove protective caps and push the
filter firmly so that you hear it lock
solidly into position.
• Open the household water line valve.
• Draw and discard 10-12 glasses of
water to freshen the supply.
• Connect unit to cold water line that
supplies water to the kitchen faucet.
• Have someone turn up the cut-off
and cut-on pressure on the water
pump system (well systems only).
• It is normal for a reverse osmosis
system to be below 20 psi during
the regenerative phase.
• See the WATER SUPPLY CONNEC-
TION section.
• Add ice to cup or container before
dispensing water.
• Add ice to cup or container before
dispensing water
27
SOLUTION