GOK SmartBox 1 Instrucciones Para El Montaje Y El Funcionamiento página 23

®
SmartBox 1, 2 and 3 has the following display:
Heat oil
-10.100L
After the level indicator has been installed, it can be started up. Before PROGRAMMING, you
need to ascertain the tank data and enter the values into the right column input value of the
following table. Then, enter the values for the individual entry steps.
Setting a
parameter:
Quitting the
setup mode:
Rain water reservoir - wiring example SmartBox
Relay 1:
6 - 7 = break contact

pump safe to run dry
Relay 2:
8 - 9 = make contact automatic backfeed

control system
storm water reservoir
level probe
Artikel-Nr. 28 100 51 h
37.400L
75%
Press [ENTER] to open setup mode.
Select the desired setting parameter via [PLUS].
Press [ENTER] to call up the value selection for the parameter.
Set the value with [MINUS]/[PLUS], press [ENTER] to save.
You can quit the setup mode at any time.
Select "Exit" and press [ENTER]
 to go back to the standard display mode.
®
SmartBox 1 / SmartBox
The device is adjusted via the three small
blue buttons:
Select the language (German, English,
French or Spanish) in menu step
18.Language.
®
2
solenoid valve for
backfeed
feed pump
®
2 / SmartBox
These are located on the
motherboard between the
terminals.
230 V AC
optional switch
drinking water
network
water for
domestic use
®
3
23 / 112