Safety Devices - BOREAL RADIOFRECUENCIA Serie Instrucciones De Instalación, Uso Y Mantenimiento

- Or also through the purchase of the optional charging kit (Kit-Car-BI7). To install the kit, you must screw the
structure (A) to the base of the insert (three screws on each side of the kit), connect to the structure (A) and to
the grate (B) the flexible feeding tube (C) 120 mm diameter (supplied in the kit), trying to avoid a deviation
of this tube higher than 45º to allow the correct fall of the pellet towards the hopper. The supplied flexible
tube is extendable up to 5 meters, so the installer must extend it and cut the measure needed for the extended
tube, otherwise the correct supply of fuel is not guaranteed.
the hopper. Keep in mind that if you decide to recharge also through the front drawer, it is possible that
part of the fuel spills out of the hopper, preventing the correct sliding of the upper drawer by its sliding
guides.
The insert model Boreal Insert 7 has a level sensor (capacitive) inside
the hopper that warns of the need to refuel. This message does not stop the operation of the device but you have a few
minutes to refuel before the insert enters into an alarm state (alarm-6 "no pellet") and stops its operation. On the remote
control you can read the message:
EMPTY
HOPPER
4.
•
MENU
If the extractor stops, the electronic card automatically blocks the fuel supply.
• BREAKDOWN OF THE FUEL LOADING MOTOR
If the geared motor stops, the stove keeps on working (only the smoke extractor) until the minimum working smoke temperature goes down and stops.
TEMPORAL POWER LOSS
•
After a short power loss, the equipment will restart automatically. However in the event of a lack of electricity the stove may give off a
small amount of smoke inside the room for a period of approximately 3-5 minutes. THIS DOES NOT ENTAIL ANY HEALTH RISK.
This is a reason why advises, whenever possible, to connect the primary air inlet pipe to the exterior of the house in order to assure that
the stove or insert does not give off smokes after a short power loss.
ELECTRICAL PROTECTION
•
The stove or insert is protected against abrupt electricity oscillations through a general fuse placed in the back part. (4A250V Retarded).
• SMOKE OUTLET PROTECTION
The electronic pressure switch blocks the operation of the stove in the event of an abrupt change of the pressure inside the
combustion chamber (door opening, breakdown of the smoke extraction motor, smoke returns, etc). If this happens, the stove
will go into an alarm state.
• PROTECTION IN THE EVENT OF HIGH TEMPERATURE OF PELLET
(80ºC)
In the event of overheating of the internal part of the tank, this device blocks the
Smoke outlet
operation of the machine. The restart needs to be done manually by an authorised
proteccion
technician.
The restoration of the 80ºC safety device is not included in the warranty unless the
technical assistance centre can demonstrate a faulty component.
You must remove the existing pre-cut sheet in the upper part of the hopper to allow
fuel to enter the hopper, and finally place the grate (B) in the coating made to the
insert, in the place it seems most suitable to facilitate loading of fuel (side, front,
rear, etc.). The minimum height between the grate and the insert to guarantee the
supply of fuel must be greater than 50 cm.
Once the kit is connected, through the loading grate and with the help of a
utensil (shovel, dispenser, etc.) pour the fuel on the grate, until you consider that
the hopper has been filled in its entirety, trying to avoid the spill of the fuel. Take
into account that the capacity of the hopper is 11 kg. You can load the fuel with
the front loading drawer closed. For this, in the process of installing the kit, you
have to break the pre-cut sheet of the base of the drawer so that the fuel enters

SAFETY DEVICES

SMOKE EXTRACTOR BREAKDOWN
B
C
50 cm
Protection
of high
temperature
EN
A
Electrical
Protection
27