Model Insert 7 - BOREAL RADIOFRECUENCIA Serie Instrucciones De Instalación, Uso Y Mantenimiento

EN
Rear exit Side exit
5.7.2

MODEL INSERT 7

The model insert 7 is composed of a fixed metal base that is inserted into the chimney gap and a
Mobile body
mobile base (body) that fits into the fixed base using extendable and removable guides.
You will need to have an electrical outlet in the back and it must be accessible once the installation
is complete. The chimney must be provided with the smoke outlet and air inlet. To place the fixed
base in the chimney gap, we must fix it with 8mm diameter metal plugs. To separate the fixed base
from the mobile base, we have to completely remove the mobile base. To do this, first open the
safety catch located on the lower right side of the front, moving the latch upwards.
Fixed base
Pull out the mobile part, tilt it upwards through the front and pull back. Thus, the two components
are separated. You must provide a support that supports the weight of the device when removing it.
Positioning the frame
The frame must be mounted once the installation is complete. For this we will perform the following steps:
Remove the appliance and place the front, fix it by means of the side screws on both sides of the appliance and take care that
the tabs of the frame remain on the outside.
In this model, you can optionally purchase a kit (kit-marco4-BI7) to convert the 3-sided standard frame, into a 4-sided frame. For
its installation you only have to screw the kit to both sides of the standard frame, with the supplied screws.
Placement of the radiofrequency receiver (display)
In the Insert 7 model, after installing the insert, you must place the radio frequency receiver of
the control command (remote control) near the device. To do this, a metal box is provided where
the receiver is placed (display). The location of the box must be on the coating itself (masonry)
made to the device. You just have to screw it in the chosen place. Note that the piece has
through the back of a "key eye" to facilitate its installation. In this way, the control will send the
radiofrequency signal to the receiver, which in turn is connected to the electronic board through
an interconnection cable. This cable will limit the distance to place the receiver with respect to
the device.
32