Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Speedaire Operating Instructions and Parts Manual
Model 1WC94
Operation
(Continued)
Safety Valve (C): If the
pressure switch does not
shut off the air compressor
at its cut-out pressure set-
ting, the safety valve will
protect against high pres-
sure by "popping out" at its
factory set pressure (slightly
higher than the pressure
switch cut-out setting).
Outlet Pressure Gauge
(D): The outlet pressure
gauge indicates the air pres-
sure available at the outlet
side of the regulator. This
pressure is controlled by the
regulator and is always less
than or equal to the tank
pressure. All four outlets
operate at this pressure.
Tank Pressure Gauge (E):
The tank pressure gauge
indicates the reserve air
pressure in the tank. The
"quadraport" is equipped
with an tank pressure gauge
to be read at a remote loca-
tion.
Regulator (F): Controls the
air pressure shown on the
outlet pressure gauge. Pull
the knob out and turn clock-
wise to increase pressure
and counterclockwise to
decrease pressure. When the
desired pressure is reached
push knob in to lock in
place.
Portable "Quadraport"
Control Panel (G): Permits
remote air regulation and
control closer to work area,
includes four high-flow
industrial/automotive style
compatible quick-connects,
large gauges, and a high-
flow regulator.
Universal Quick-Connect
Body (H): The universal
quick-connect body accepts
the three most popular
styles of quick-connect
plugs: Industrial, automotive
(Tru-flate), and ARO. One
hand push-to-connect opera-
tion makes connections sim-
ple and easy.
HOW TO USE YOUR
UNIT
:
HOW TO STOP
Set the On/Auto/Off lever
to "OFF".
BEFORE FIRST START-UP
Serious
damage may result if the
following break-in
instructions are not close-
ly followed.
This procedure is required
before the air compressor is
put into service and when
the check valve or a com-
plete compressor pump has
been replaced.
1. Make sure the
On/Auto/Off lever is in the
"OFF" position.
13
NOTE: If quick connect is
installed, pull coupler back
until it clicks to prevent air
from escaping through the
quick connect.
2. Plug the power cord into
the correct branch circuit
receptacle. (Refer to
Voltage and Circuit
Protection paragraph in
the Installation section of
this manual.)
3. Open the drain valve fully
(counterclockwise) to per-
mit air to escape and pre-
vent air pressure build up
in the air tank during the
break-in period.
NOTE: Always drain tank on
a washable surface or in a
suitable container to pre-
vent damaging or staining
surfaces.
4. Move the On/Auto/Off
lever to "ON/AUTO" posi-
tion. The compressor will
start.
5. Run the compressor for 15
minutes. Make sure the
drain valve is open and
there is minimal air pres-
sure build-up in tank.
6. After 15 minutes, close
the drain valve (clock-
wise). The air receiver will
fill to "cut-out" pressure
and the motor will stop.
The compressor is now ready
for use.
E
N
G
L
I
S
H
Publicidad
Tabla de contenido
