Speedaire Operating Instructions and Parts Manual
Speedaire
E
N
G
L
I
S
H
WHAT CAN HAPPEN
THE COMPRESSED AIR DIRECTLY FROM YOUR
COMPRESSOR IS NOT SAFE FOR BREATHING.
THE AIR STREAM MAY CONTAIN CARBON
MONOXIDE, TOXIC VAPORS, OR SOLID PARTI-
CLES FROM THE TANK. BREATHING THESE CON-
TAMINANTS CAN CAUSE SERIOUS INJURY OR
DEATH.
SPRAYED MATERIALS SUCH AS PAINT, PAINT
SOLVENTS, PAINT REMOVER, INSECTICIDES, AND
WEED KILLERS, MAY CONTAIN HARMFUL
VAPORS AND POISONS.
WHAT CAN HAPPEN
TOUCHING EXPOSED METAL, SUCH AS THE
COMPRESSOR HEAD OR OUTLET TUBES, CAN
RESULT IN SERIOUS BURNS.
®
"Site Boss" Air Compressor
HAZARD
RISK TO BREATHING
HAZARD
RISK OF BURNS
HOW TO PREVENT IT
AIR OBTAINED DIRECTLY FROM THE COMPRES-
SOR SHOULD NEVER BE USED TO SUPPLY AIR
FOR HUMAN CONSUMPTION. IN ORDER TO USE
AIR PRODUCED BY THIS COMPRESSOR FOR
BREATHING, SUITABLE FILTERS AND IN-LINE
SAFETY EQUIPMENT MUST BE PROPERLY
INSTALLED. IN-LINE FILTERS AND SAFETY
EQUIPMENT USED IN CONJUNCTION WITH THE
COMPRESSOR MUST BE CAPABLE OF TREATING
AIR TO ALL APPLICABLE LOCAL AND FEDERAL
CODES PRIOR TO HUMAN CONSUMPTION.
WORK IN AN AREA WITH GOOD CROSS-VENTI-
LATION. READ AND FOLLOW THE SAFETY
INSTRUCTIONS PROVIDED ON THE LABEL OR
SAFETY DATA SHEETS FOR THE MATERIAL YOU
ARE SPRAYING. USE A NIOSH/MSHA
APPROVED RESPIRATOR DESIGNED FOR USE
WITH YOUR SPECIFIC APPLICATION.
HOW TO PREVENT IT
NEVER TOUCH ANY EXPOSED METAL PARTS
ON COMPRESSOR DURING OR IMMEDIATELY
AFTER OPERATION. COMPRESSOR WILL REMAIN
HOT FOR SEVERAL MINUTES AFTER OPERATION.
DO NOT REACH AROUND PROTECTIVE SHROUDS
OR ATTEMPT MAINTENANCE UNTIL UNIT HAS
BEEN ALLOWED TO COOL.
6
1WC94