Storage And Transportation - Speedaire Site Boss Manual De Instrucciones De Operación Y Lista De Partes

Speedaire Operating Instructions and Parts Manual
Model 1WC94
Service and
Adjustment
(Continued)
9. Clean or replace the
check valve. A solvent,
such as paint or varnish
remover can be used to
clean the check valve.
10. Apply sealant to the
check valve threads.
Reinstall the check valve
(turn clockwise).
11. Replace the pressure
release tube. Tighten
nut.
12. Replace the outlet tube
and tighten nut.
13. Replace the shroud and
air filter.
14. Perform the Break-in
Procedure. See "Break-in
Procedure" in the
Operation section.
STORAGE AND
TRANSPORTATION
Before you store the air
compressor, make sure you
do the following:
1. Review the "Maintenance"
section on the preceding
pages and perform sched-
uled maintenance as nec-
essary.
2. Set the "ON/AUTO" lever
to "OFF".
3. Turn the regulator coun-
terclockwise and set the
outlet pressure to zero.
4. Remove the air tool or
accessory.
TANK CAN
CONTAIN 175 PSI OF AIR
PRESSURE. ALWAYS
STAND CLEAR WHEN
BLEEDING AIR THROUGH
SAFETY VALVE.
5. Pull ring on safety valve
allowing air to bleed
from the tank until tank
pressure is approximate-
ly 20 psi. Release safety
valve ring.
6. Drain water from air
tank by opening drain
cock valve on bottom of
tank.
WATER WILL
CONDENSE IN THE AIR
TANK. IF NOT DRAINED,
WATER WILL CORRODE
AND WEAKEN THE AIR
TANK CAUSING A RISK OF
AIR TANK RUPTURE.
7. After the water has
been drained, close the
drain cock or drain valve.
NOTE: If drain cock valve is
plugged, release all air pres-
sure. The valve can then be
removed, cleaned, then rein-
stalled.
8. Protect the electrical
cord and air hose from
damage (such as being
stepped on or run over).
9. While lifting tab (A)
rotate handle (B) into
storage position. See
Figure.
17
A
10. Store the air compressor
in a clean and dry loca-
tion.
TO TRANSPORT UNIT
1. Fold handles into storage
position.
The unit is
too heavy to be lifted by
one person. Use two peo-
ple to lift unit.
2. Locate the lift handles (C)
on each side of the unit.
C
3. With a person on each
side, carefully lift unit
using handle (B) and lift
handle (C). See Figure .
Always lift
with legs not back.
E
N
G
B
L
I
S
H
B