Cooktop Installation - IKEA NEDDRAGEN Manual De Instrucciones

Your appliance has a 4-wire cable to be
connected to a 4-wire grounded junction box
(see figure 7):
1. Disconnect the power supply.
2. In the junction box:
Connect appliance and power supply cable wires
as shown in Figure 7.
Cable from Power Supply
Ground
Wire
Red
Wires
Ground
Wire
(Bare or
Green Wire)
Junction
Box
Cable from appliance
4-WIRE GROUNDED JUNCTION BOX

Cooktop Installation

1. Visually inspect the cooktop for damage. Also
make sure all cooktop screws are tight (see
Figure 8).
2. Set the cooktop into the countertop cutout.
Figure 8
WARNING!
Do not remove the built in springs on the
edges of the cooktop. These springs center
the cooktop in the space provided. The
cooktop must be centered to prevent excess
heat buildup that may result in heat damage
or fire (see Figure 9).
White
Wires
Black
Wires
U.L.-Listed Conduit
Connector (or CSA listed)
Figure 7
Screws
8 Built-in
Springs
2 Retainer
Brackets
During the installation with wide cutout, make sure
the cooktop is centered. A and B gap should have
the same dimensions. The elongated holes on the
bottoms of the installation brackets are made to fit
every cutout.
The retainer brackets MUST be installed, to
meet local codes or, in their absence, with
the National Electrical Code ANSI/NFPA No.
70—latest edition, or with CSA Standard
C22.1, Canadian Electrical Code, Part 1 (see
Figure 11).
Cooktop
Built in
Spring
Retainer Bracket
Screw 1
Figure 11
Position brackets
on unit cutout
center line (CL)
Figure 9
Figure 10
Countertop
Retainer Brackets
Must Be Installed At
Least 1/8" (0.3 cm)
BELOW Countertop
Screw 2
9