Memory - Displaying The Last 120 Measurements; Viewing The Stored Values; Memory Full - Microlife BP3GT1-6X Manual De Instrucciones

5.5. Memory – displaying the last 120 measurements
At the end of a measurement, this monitor automatically stores each result with date
and time. This unit stores 120 memories for each of 2 users.

Viewing the stored values

With the unit unlocked, press "M." The display first shows "A," then shows an average
of all measurements stored in the unit. Please note: Measurements for each user are
averaged and stored separately. Be certain that you are viewing the measurements for
the correct user.
Pressing "M" again displays the previous value. Repeat to scroll to that stored reading.
To move out of viewing memories, press STOP.

Memory full

When the memory has stored 120 results, a new, measured value is
stored by overwriting the oldest value.
Clear all values
If you are sure that you want to permanently remove all stored values,
hold down "M" until "CL" appears and then release "M". If you do not
want to clear the values, press STOP. To permanently clear the memory,
press "M" while "CL" is flashing.
Individual values cannot be cleared.
14