Memory - Displaying The Last 99 Measurements; Memory Full; Discontinuing A Measurement - Microlife CVS/pharmacy BP3MC1-PC Instrucciones De Uso

5.7. Memory – Displaying the last 99 Measurements
At the end of a measurement, this monitor automatically stores each result with date and
time. This unit stores 99 memories for each of 2 users.
Viewing the stored values
With the unit off, press the "M" button. The display first shows "A", then shows an average of
all measurements stored in the unit. Please note: Measurements for each user are
averaged and stored separately. Be certain that you are viewing the measurements
for the correct user.
Pressing the "M" button again displays the previous value. To view a particular stored memo-
ry, press and hold the "M" button to scroll to that stored reading.

Memory full

When the memory has stored 99 results a new measured value is stored by overwriting the
oldest value.
Clear all values
If you are sure that you want to permanently remove all stored values, hold
down the "M" button (the instrument must have been switched off before-
hand) until "CL" appears and then release the button. If you do not want to
clear the values, press the Start/ON/OFF button. To permanently clear the
memory, press the "M" button while "CL" is flashing.
Individual values cannot be cleared.
1

5.8. Discontinuing a Measurement

Start
If it is necessary to interrupt a blood pressure measurement for any
ON/OFF
reason (e.g the patient feels unwell), the Start/ON/OFF button can
be pressed at any time. The device then immediately lowers the
cuff pressure automatically.
14