SEVERIN 1372043 Instrucciones De Uso página 11

surfaces as well as the heating element
and the grill rack become very hot during
operation. Even after the heating
element is switched off, it must not be
touched until it has sufficiently cooled
down - there is otherwise a severe danger
of burns.
●
To avoid the risk of electric shock, the
heating element and the power cord
must not be immersed in liquid or even
allowed to come into contact with it.
●
Do not allow the power cord to touch
any hot parts of the appliance.
●
The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
●
Always remove the plug from the wall
socket
- after use,
- in case of any malfunction, and
- during cleaning.
●
The use of an extension-lead reel causes
a loss of power, possibly combined with a
subsequent heat build-up in the cable. It
is therefore necessary to unwind the
cable completely if a cable reel is used.
Make sure that the reel is approved for
outdoor use by the manufacturer.
●
The appliance is not intended to be
operated by means of an external timer
or separate remote-control system
●
Before carrying, transporting or storing
the grill, ensure that is has sufficiently
cooled down. Pour out any remaining
water after use.
●
Ensure that the grill is not stored
outdoors, or in any other location where
it might be subjected to extremes of
temperature or high humidity.
●
No responsibility can be/will be accepted
if damage results from improper use, or if
these instructions are not complied with.
●
This barbecue grill is intended for
domestic use only and not for
commercial applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Grill with additional base stand:
Assemble the base stand according to the
schematic diagram supplied, and then place
the grill onto the stand. The small feet under
the grill connect with the tops of the vertical
legs of the base stand.
Ensure that the grill and base stand are
placed in a safe and stable position. The
power cord should be routed in such a way
that no one is likely to trip over it.
Heating element
The junction box contains a safety switch.
Place the heating element into the grill pan.
The safety switch is activated automatically
when the heating element has been properly
fitted. If not fitted correctly, the appliance
can not be switched on.
Before using for the first time
- Remove any packaging materials from
the appliance.
- Clean the grill rack and grill pan with
warm soapy water.
- Grill assembly:
1. Place the heating element into the grill
pan.
2. Fit the grill rack on top.
3. If required, additional accessories may
be fitted according to the diagram
shown in the instructions.
- Fill the grill pan with water up to the
'Max' marking.
- Let the grill heat up for approximately 5
minutes without any food on the rack.
This will lessen the smell typically
encountered when first switching on a
new grill (a slight smell and a little smoke
may be emitted - ensure sufficient
ventilation).
11