Care And Maintenance; Troubleshooting; Corrective Action - Kobalt KSP 1024B-03 Manual Del Usuario

CARE AND MAINTENANCE

All maintenance should only be carried out by a qualified service technician.
WARNING
• Before cleaning or performing any maintenance, remove the battery from the tool. Never
disassemble the tool, battery pack or charger. For safe and proper operation, always keep
the tool and its ventilation slots clean.
• To reduce the risk of personal injury and damage, never immerse your tool, battery pack or
charger in liquid or allow a liquid to flow inside them.
Cleaning
• If there is any liquid left in the tank after
spraying, the tank should be drained before
cleaning.
• Always use only a soft, dry cloth to clean
outside of the tank; never use detergent or
alcohol.
• Fill the tank about one-third full with clean water.
Spray until the tank has been emptied. Make
sure to direct the spray toward an area that will
not be damaged by the spray solution.
• Refill and repeat the procedure with clean water.
It may be necessary to rinse the tank more than
once, then drain again as directed above.
• Allow all pieces to completely dry before
reinstalling parts and storing the unit.
Cleaning the Nozzle
If the nozzle becomes obstructed, follow the steps below to clear it.
• Remove the battery pack.
• Unscrew and remove the nozzle from the spray wand.
• Push a small wire (not included) through the cross holes to clear any debris. If necessary,
rinse the cross holes and nozzle with clean water.
• Wipe the nozzle and cross holes with a clean dry cloth and reinstall the nozzle.

TROUBLESHOOTING

WARNING
Turn the switch to the "OFF" position, and remove battery from the tool before performing
troubleshooting procedures.
PROBLEM
Tool does not work.
POSSIBLE CAUSE
1. Low battery capacity.
2. The battery pack or sprayer
is too hot.
13
8
Nozzle

CORRECTIVE ACTION

1. Charge the battery pack.
2. Turn off the sprayer and
allow the sprayer and
battery pack to cool.