Care And Maintenance - Kobalt SGY-AIR86TZ Manual Del Usuario

REPAIR INSTRUCTIONS
NOTE: Test spray pattern before use again.
During normal use, the air cap wings are horizontal and the air cap should be pointed
up as shown here. (See Figure 13) This provides a vertical fan-shaped pattern which
gives maximum and even material coverage as the gun is moved back and forth
parallel to the surface being finished.
13
The air cap wings
are horizontal.

CARE AND MAINTENANCE

Disconnect and remove air hose and sprayer.
1. Submerge the front end of the gun in solvent just until the fluid connection is
covered.
2. Paint that has built up on the gun should be removed using a bristle brush and
solvent.
3. Never submerge all the spray gun in solvent as:
a. Air passages in the gun will become clogged with dirty
solvent.
b. This will dissolve the lubricant in the leather packing and on
wear surfaces, causing them to dry out resulting in difficult
operation and faster wear.
4. Using a rag moistened with solvent, wipe down the outside of
the gun.
5. Oil gun daily. Use a drop of lightweight machine oil on:
a. fluid needle packing
b. air valve packing
c. trigger pivot point
See Figure 14 for location of the above points.
CAUTION: Do not use lubricants which contain silicone. Silicone may cause defects
in the finish application.
10
14
c
a
b