Binding For 2.4 Ghz R/C System - Carson Bluster 500 Instrucciones De Uso

c. Binding for 2.4 GHz R/C System
1.
First press the button for the binding process. Then switch on
the transmitter.
3.
If the binding process is successful, the LED on the receiver
goes out.
You can now remove the jumper from "BATT" port again.
CARSON 3D Helicopter Bluster 500 · 50 050 7036
2.
To supply the required voltage to the receiver, connect the
regulator to the receiver.
The LED starts to flash. Now plug the binding jumper supplied
into the port marked "BATT".
4.
Now press the button for the binding process again.
The transmitter reverts to "normal" mode.
5.
The LED will again light up for a few seconds after the binding
jumper has been removed.
This confirms that the binding process has been completed.
GB
11