Carson Bluster 500 Instrucciones De Uso página 19

Tail rotor system check:
1. Make sure the tail gear set is working correctly. There should
be no gaps at the gears and gear mesh should be smooth
with no binding. If there are any teeth missing on the gears
or binding the gears should be replaced before the next
flight.
2. Make sure that there is no grass in the gear system when
flying in grassy areas. Do not oil the exposed gears since
this can attract dirt which will rapidly wear out the gears and
gear mesh.
Caution:
Check all of the fasteners and screws prior to the start of
a flight, loose screws can cause unexpected accidents and
possible crash or personal injury..
CARSON 3D Helicopter Bluster 500 · 50 050 7036
3. Take apart the tail system after 50 flights and clean the gears
and drive train. Inspect the gear set and replace any worn or
damaged gears/ gear mesh.
4. Should your helicopter hit the ground hard, inspect for
damage immediately, replace any component that is
damaged with a new part prior to flying again.
GB
19