Faucet Installation - Kohler K-7323 Guia De Instalacion

Faucet
2-1/8"
(5.4 cm)
Max
Washer
Screw
Threaded Ring

1. Faucet Installation

Mark the position of the mounting hole at the intended faucet
installation location.
Verify adequate reach of the faucet for your intended use.
Drill a 1-1/8" (2.9 cm) to 1-3/8" (3.5 cm) hole at the marked
location.
Verify the O-ring is installed in the underside of the escutcheon.
If desired, sealant may be applied to the underside of the
escutcheon.
Slide the escutcheon onto the faucet.
Insert the shank through the mounting hole.
Partially thread two screws into the threaded ring until the
screws barely protrude from the back side of the threaded ring.
Slide a metal washer onto the threaded shank from underneath
the mounting surface.
Kohler Co.
Escutcheon
Screw
3
Faucet
Escutcheon
Washer
Threaded Ring
Shank
Supply Hose
(Not Provided)
1047607-2-C