Mounting; Electrical Installation - SICK WLG16 Instrucciones De Uso

4

Mounting

5

Electrical installation

8021959.10DR | SICK
Subject to change without notice
Fixing hole Ø 4,1 mm
2
Connection
3
LED indicator green: supply voltage
4
active
LED indicator yellow: status of
5
received light beam
Press-turn element: adjustment of
6
mode and sensitivity
BluePilot blue: mode selection
7
Mount the sensor and the reflector using suitable mounting brackets (see the SICK
range of accessories). Align the sensor and reflector with each other.
Note the sensor's maximum permissible tightening torque of < 1,3 Nm.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: Note pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanations of the connection diagram
Alarm = alarm output (table
Health = alarm output (table
MF (pin 2 configuration) = external input, teach-in, switching signal
Q / C = switching output, IO-Link communication
L1
> 0 V) once all electrical connec‐
V
(table 1 - table
4)
4)
MOUNTING
= 0 V). The following informa‐
V
2).
4
5