Cable Cover Installation - NDS EndoVue Plus Manual Del Usuario

Cable Cover Installation

1. Remove and save the cable cover retaining screws located at points andon Figure 1, slide the cable
cover down, and lift it off the display.
2. Connect the power, and video cables. Connect the equipotentiality (Figure 2 detail) cable to the
display.
3. Place the cable cover (Figure 3) on the flat surface below the connector panel (Figure 2). Slide the cable
cover up until the tabs along the front of the cover (Figure 3) are seated in the slots at the top of the
connector panel. See figure 4 detail .
4. Secure the cable cover using the retaining screws that were removed in step1. Refer to Figure 1 for the
locations of the retaining screws.
Note: The cable cover must be removed prior to adding or removing cables.
Figure 1 with Cable Cover
Figure 2 without Cable Cover
Figure 3 Cable Cover
Figure 4 Cable Cover alignment slots
14