Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E. Installing the software
Minimum configuration:
- Windows 7, Windows 8, Windows 10
- Core i5 1.7GHz / 4Go
- USB Port
- PDF reader
1.
On the provided USB stick, double-click on the software installation
icon.
2.
Click on [Run] and choose the language for the installation assistant,
then click on [OK].
3.
Accept the license terms and click on [Next].
4.
Choose the destination folder for the software and click on [Next].
5.
Click on [Install] to start the installation.
The software must be installed on the local hard drive of the
computer connected to the Mixolab. An installation on a network
location can cause errors.
6.
Once the installation has completed, a window will appear to allow
you to extract and install the USB drivers. Click on [Extract].
7.
Once the file has been decompressed, an installation window will
appear. Click on [Next] then on [Finish].
8.
When the software is run for the first time, the message below will
appear.
Click on OK, then select the folder where the database will be
created and saved.
If the USB driver is not fully installed, click on the executable file supplied
on the USB stick.
F. Powering Up
Before powering up the device:
1.
Fill the tank with distilled water
2.
Place the nozzle over the water tank
Then :
3.
Switch the device on by using the switch located on the rear of the device.
4.
An LED located on the front will flash red/orange/green during the initialization phase, which lasts between one and two
minutes.
1
Windows 7, Windows 8
Windows 10
2
2
3
5
7
3
4
6
8
4
Publicidad
Tabla de contenido
