STORZ & BICKEL HYBRID Volcano Modo De Empleo página 75

6. GENERAL INFORMATION ABOUT THE VOLCANO HYBRID
Problem
The display shows:
1. Line: "ERR"
2. Line: Number + letter
"r" or "n"
Possible error mes-
sages
01r
02r
03r
04n
bl 000
Device switches off
(automatic switch off)
Possible Cause/Remedy
Fault in the device. Perform a factory reset if
number + "r" is displayed. Display of number + "n" is
an irreversible error; the Hot Air Generator must be
sent to our Service Center.
Error in internal communication. Restart recom-
mended.
The device is either outside its specified tempera-
ture, or internal overheating has occurred. Switch
the device off, pull the power plug out of the socket,
and leave the device for min. 30 mins at room tem-
perature without operating it. If the fault continues
after 30 mins., contact our Service Center.
The device is being operated at the incorrect volta-
ge. Please check which version (115V/230V) of the
device you have, and ensure that you are using it at
the correct voltage.
Device is defective; please send to our Service
Center
The firmware has an error and requires a mandato-
ry firmware update via the app.
If the firmware update fails several times, please
send the device to our Service Center.
Automatic switch off has tripped. Switch the heater
or pump back on.
73