Application Of The Volcano Hybrid Filling Chamber - STORZ & BICKEL HYBRID Volcano Modo De Empleo

7. O P E R AT I N G T H E V O L C A N O H Y B R I D
7.5. Application of the
VOLCANO HYBRID
Filling Chamber
Turn the Filling Chamber Cap counter-
clockwise in order to remove it from
the Filling Chamber.
Remove Filling Chamber Cap
Fill the Filling Chamber with the de-
sired amount of ground plant material
up to the lower edge of the hopper.
Fill the Filling Chamber to the bottom edge
of the hopper at most
Next screw on the Filling Chamber Cap
again.
Screw on Filling Chamber Cap
Take care that the Screens are
not obstructed with plant ma-
terial. To guarantee optimal re-
sults, we recommend cleaning the
Screens after each vaporization cycle
with the enclosed Cleaning Brush.
Place the Filling Chamber with Cap on
the hot air outlets of the Hot Air Gener-
ator and screw it on clockwise. When
screwing on, please make sure that you
do not exert too much pressure and do
not overtighten the threads. Switch on
the pump. To do this, tap the touch but-
ton pump (AIR). The Filling Chamber as
well as the vaporization material must
be preheated for a couple of seconds
79