Ace Heath Zenith 598-1214-03 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Check operation and adjustment
Note: When first turned on or when switching
modes wait 1
The RANGE control and ON-TIME control are
located on the bottom of the sensor (see Figure 6).
Using your fingernails or a small, flat-head screw-
driver, gently pry the cover until it opens.
1. Check Operation. Set the ON-TIME control to
TEST mode. Walk in front of sensor unit. The
LED indicator light located on the bottom of
the sensor should flash when motion is detected
(see Figure 6).
2. Adjust Sensor. Turn the RANGE control to the
mid position and ON-TIME control to the TEST
position (see Figure 6). Walk through coverage
area noting where you are when the LED begins
to flash. Loosen the clamp screw and move the
sensor to change the coverage area (see Figure
7). Tighten clamp screw when finished. Do not
overtighten clamp screw.
ON-TIME
Control
Figure 6 - Motion Sensor Controls (Bottom View)
10
/
minutes.
1
2
ON-TIME
MAX
(MINUTES)
5
1
TEST
RANGE
MIN
Sensitivity
Control
LED Indicator
598-1214-03

Publicidad

Tabla de contenido
loading

Productos relacionados para Ace Heath Zenith 598-1214-03

Tabla de contenido