Remote Control - Ace Heath Zenith 598-1214-03 Manual De Instrucciones

One remote control is able to independently operate
two receiver units. If more than two receiver units,
operating independently, are desired, additional
remote controls will need to be purchased.
1. Remove Tab from Battery Chamber. Remove
cover from back of transmitter. Gently pull tab
out of battery chamber (see Figure 1). Slide
cover onto transmitter.
Battery Chamber
(Type A23)
Figure 1 - Rear View of Remote Control
2. Remote Control Functions. The three buttons
on the left side of the remote will operate one
or more receiver units with matching code set-
tings. The three buttons on the right side of the
remote will operate a second set of one or more
receiver units (see Figure 2).
• on: Turns on any receiver unit set to the same
code as this remote control.
• oFF: Turns off any receiver unit set to the same
code as this remote control.
598-1214-03

reMote ControL

ON DIP ON DIP
1 2 3 4 1 2 3 4
Tab
Battery Cover
5