Installing Batteries - Ace Heath Zenith 598-1214-03 Manual De Instrucciones

WireLess Motion sensor
Features:
• No wiring required.
• Up to 70 feet sensing range, 180° Coverage.
• Adjustable sensitivity.
• Day/Night or Night only operation.
• Test mode.
• Uses 2 AA batteries.
• Wall or eave mount.
• Controls receivers up to 100 feet away.
select night or 24 hour Mode
This sensor is able to detect motion day and night or
night only. To set the detection mode, remove rear
panel by sliding the panel down. Remove batteries
if necessary. Slide the DETECT switch to either the
DAY/NIGHT or NIGHT ONLY position. Replace
rear panel by reversing the above instructions.

installing Batteries

Before mounting sensor, remove rear panel by
sliding the panel down. Install 2 AA batteries
according to polar-
ity markings inside
the battery compart-
ment (see Figure 4).
Replace rear panel
by reversing the
above instructions.
8
DAY NIGHT
NIGHT ONLY
1 2 3 4
DETECT
CODES
Figure 4 - Battery
Compartment (Rear View)
Polarity
Mark
Detect
Control
598-1214-03