reCeiVer inForMation
All receivers have the following features and ratings:
• Rated for 120VAC/60Hz supply voltage.
• Light can be dimmed when used with remote
control (OFF, 5 Selectable Dim Levels from
Dimmest to Brightest, Full On).
• Remembers last selected dim setting.
• Not for use with Compact Fluorescent bulbs.
• When first turned on wait 15 seconds.
FLoodLight ConVerter
Features and ratings:
• Up to 150 Watt maximum incandescent load or
240 Watt maximum halogen load (up to 75 Watt
maximum incandescent, or 120 Watt maximum
halogen, per lamp holder).
• Minimal wiring required.
• Install fixture in accordance with local codes.
Warning: turn power off at the fuse or
circuit breaker.
1. Remove the existing light fixture.
2. Install the mounting strap as shown using two
screws that fit your junction box (see Figure 10).
White to White
Mounting
Strap
Junction box ground wire to
green ground screw on fixture.
Figure 10 - Wiring Floodlight Converter
598-1214-03
Black to Black
Gasket
Rubber Plug
Mounting
Bolt
13