Ace Heath Zenith 598-1214-03 Manual De Instrucciones página 9

installing Motion sensor
1. Install sensor mounting bracket where motion
detection is desired. Attach sensor mounting
bracket to a sturdy object (i.e. tree, post, house,
etc.) using two screws provided (see Figure 5).
Make sure unit has an unobstructed view. Note:
If mounting bracket to a curved surface, attach
mounting bracket vertically.
2. Install motion sensor to mounting bracket. Us-
ing a Philips-head screwdriver, loosen the clamp
screw on the mounting bracket. Insert swivel
ball mount on sensor into mounting bracket
socket (Note: You should hear a snap). Aim
sensor toward area where detection is desired.
Tighten clamp screw (see Figure 5).
ImporTaNT: The sensor must be mounted with
the bottom cover facing down in order to maintain
water tightness.
Mounting Bracket
Socket
Clamp Screw
Swivel Ball Mount
Figure 5 - Installing Motion Sensor
598-1214-03
Sensor
Mounting Bracket
Mounting Screw
Nut
9