Ace Heath Zenith 598-1214-03 Manual De Instrucciones página 16

5. Adjust audio alert volume. The alarm sounds
only when the receiver is activated by the wire-
less motion sensor and entry switch. The alarm
volume is adjusted by the thumbwheel on the
side of the receiver unit (see Figure 11).
Speaker
LaMP soCket ConVerter
Features and Ratings:
• Up to 150 Watt maximum incandescent load.
• No wiring required.
1. Screw module into light socket.
2. Screw incandescent bulb up to rated wattage
into module.
Caution: do not exceed the maxi-
mum load limits listed above.
3. Check operation. Activate transmitter being used
with receiver (see transmitter instructions). A
signal will be sent to the receiver to turn the
receiver ON or OFF.
ACE reserves the right to discontinue products
®
and to change specifications at any time without
incurring any obligation to incorporate new features
in products previously sold.
1
Figure 11 - Control Locations
Remote By-Pass
Switch
Alarm Volume
Control
598-1214-03