Important Charging Notes; Storage Recommendations - DeWalt DWST1-75659-QW Traducido De Las Instrucciones Originales

English

IMPORTANT CHARGING NOTES

1. Longest life and best performance can
be obtained if the battery pack is charged
when the air temperature is between 65
°F and 75 °F (18–24 °C). DO NOT charge
the battery pack in an air temperature
below +40 °F (+4.5 °C), or above +105
°F (+40.5 °C). This is important and will
prevent serious damage to the battery
pack..
2. The charger and battery pack may
become warm to the touch while
charging. This is a normal condition, and
does not indicate a problem. To facilitate
the cooling of the battery pack after use,
avoid placing the charger or battery pack
in a warm environment such as in a metal
shed or an uninsulated trailer.
3. A cold battery pack will charge at about
half the rate of a warm battery pack. The
battery pack will charge at that slower
rate throughout the entire charging cycle
and will not return to maximum charge
rate even if the battery pack warms.
4. If the battery pack does not charge
properly:
a. Check operation of receptacle by
plugging in a lamp or other appliance;
b. Check to see if receptacle is
connected to a light switch which turns
power off when you turn out the lights;
c. Move the charger and battery pack
to a location where the surrounding air
temperature is approximately 65–75 °F
(18–24 °C);
d. If charging problems persist, take the
battery pack and charger to your local
service center.
5. The battery pack should be recharged
when it fails to produce sufficient
power on jobs which were easily done
previously. DO NOT CONTINUE to use
the pack under these conditions. You
may also charge a partially used pack
with no adverse effect on the battery
pack.
6. Foreign materials of a conductive nature
such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil, or
any buildup of metallic particles should
be kept away from charger cavities.
Always unplug the charger from the
power supply before attempting to clean.
44
7. DO NOT freeze or immerse the charger
in water or any other liquid.
WARNING: Shock hazard. Don't
allow any liquid to get inside the
charger. Electric shock may result.
WARNING: Burn hazard. DO NOT
submerge the battery pack in any liquid
or allow any liquid to enter the battery
pack. NEVER attempt to open the
battery pack for any reason.
If the plastic housing of the battery pack
breaks or cracks, return to a service
center for recycling.
CAUTION: Danger of explosion if
battery is incorrectly replaced.
Replace only with the
same or equivalent type.
NOTE: The ToughSystem Music + Charger
favors superior DAB reception over fast
charging. In low reception areas, the charging
rate will be reduced to permit maximum
reception sensitivity.

STORAGE RECOMMENDATIONS

1. The best storage place is one that is
cool and dry, away from direct sunlight
and excess heat or cold.
2. For long-term storage, it is
recommended to store a fully charged
battery pack in a cool dry place out of
the charger for optimal results.
NOTE: Battery packs should not be
stored completely depleted of charge.
The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
CHARGING A BATTERY PACK
The DWST1-75659-QW / DWST1-75663-GB / DWST1-75664-XE includes a top compartment
that is mainly used to store and protect the AC/DC power adaptor when not in-use.
1. Open the top compartment to take out
the AC/DC power adaptor (see Figure 1
and Figure 3).
2. Plug the charger AC/DC power adaptor
into an appropriate outlet and connect
it to the DWST1-75659-QW / DWST1-
75663-GB / DWST1-75664-XE power-in
port before inserting the battery pack
(see Figure 2).
3. Open the battery pack cover by
releasing its two latches (see Figure 2).
4. Insert the battery pack (not included) into
LCD INDICATORS
When the appliance is turned OFF
When charging a battery pack while the
appliance is turned off, a large battery image
is displayed in the center of the LCD screen
showing the battery pack charging status.
Battery pack is empty
Battery pack level is low
Battery pack is partially charged
Battery pack is fully charged
Hot/Cold Delay
This charger has a hot/cold delay
feature: when the charger detects a
battery that is hot, it automatically
starts a delay, suspending charging
until the battery has cooled. After
the battery has cooled, the charger
automatically switches to the
pack charging mode. This feature
ensures maximum battery life.
English
the charger, making sure the pack is fully
seated in the charger
see Figure 4). The battery indicator
image will blink continuously, indicating
that battery charging is in process.
NOTE: Close the battery pack cover and
check it is tightly closed.
5. The completion of charging will be
indicated by a steady battery indicator
image. The pack is fully charged and
may be used at this time or left in the
charger.
When the appliance is turned ON
When the DWST1-75659-QW / DWST1-75663-
GB / DWST1-75664-XE is on, indicators for
the power supply and the battery status are
displayed on the lower right portion of the LCD
screen.
Appliance is operating via the AC/
DC power adaptor
Battery level is low
Battery is partially charged
Battery is fully charged
Hot/Cold delay of charging
45