Remote Control - Yamaha MCR-E410 Manual De Instrucciones

Controls and Functions

Remote control

INPUT
DISPLAY
CD
TAPE/MD
Common
functions
1
STANDBY/ON STANDBY/ON
2
1
1
5
5
9 9
PROG PROG
TIME/INFO TIME/INFO
FOLDER/PRESET FOLDER/PRESET
FILE FILE
/A-E /A-E
3
INPUT INPUT
4
5
CD CD
TAPE/MD TAPE/MD
8
En
VOLUME
SLEEP
TUNER BAND
AUX/TV DOCK
Input
selection
keys
2 3 4
2 3 4
6 7 8
6 7 8
6
DIMMER
DIMMER
0 0
FREQ/TEXT FREQ/TEXT
REPEAT REPEAT
PTY SEEK
PTY SEEK
MODE MODE START START
RANDOM RANDOM
MENU MENU
FILE FILE
ENTER
ENTER
/A-E /A-E
VOLUME VOLUME
DISPLAY DISPLAY
7
SLEEP SLEEP
TUNER TUNER BAND BAND
8
AUX/TV AUX/TV DOCK DOCK
This remote control can operate the PianoCraft system
components (including tuner functions) and an iPod
stationed in a YAMAHA iPod universal dock connected to
the receiver.
To operate the CD player, tuner functions, or an iPod
using the remote control, you need to set the receiver to
the corresponding input mode.
To switch the input mode of the receiver
Press the corresponding input selection key on the remote
control (or INPUT on the front panel).
The name of the corresponding input source appears in the
front panel display of the receiver.
y
For a complete list of the remote control functions used to control
your iPod, refer to "Available iPod operations" (see page 35).
Operations common to all modes
The following operations are available for the receiver
when it is set to any input mode.
1 Infrared signal transmitter
Sends signals to the component you want to control.
2 STANDBY/ON (
Turns the receiver on or sets it to the standby mode.
3 DISPLAY
Switches the information shown in the front panel display
(see page 20).
4 INPUT
/
Selects the input source on the receiver.
5 SLEEP
Sets the sleep timer on the receiver (see page 33).
6 DIMMER
Changes the brightness of the receiver's front panel
display (see page 20).
7 VOLUME +/–
Adjusts the overall volume level on the receiver.
8 Input selection keys
Select the input source on the receiver.
y
STANDBY/ON, DIMMER and SLEEP operations also control
the CD player by the system control connection (see page 12).
)