Adjusting The Clock - Yamaha MCR-E410 Manual De Instrucciones

ADJUSTING THE CLOCK

Before starting playback operation, follow the procedure below to adjust the clock setting of the receiver.
DISPLAY
NATURAL SOUND STEREO RECEIVER RX-E410
DISPLAY MEMORY
TIMER
TIME ADJ
BASS TREBLE
STANDBY/ON
PHONES
STANDBY/ON TIME ADJ PRESET/BAND
1
Press STANDBY/ON on the front panel of the
receiver to turn on it.
The front panel display lights up.
2
Press DISPLAY.
"Clock Time" appears in the front panel display for a
few seconds, and then "Set Clock" appears.
3
Press TIME ADJ for about two seconds to
enter the clock setting mode.
4
To set the hour setting ahead, press HOUR
repeatedly. To set the hour setting backward,
press HOUR repeatedly while holding down
PRESET/BAND.
18
En
Adjusting the Clock
HOUR MIN
PURE DIRECT
AUTO/MAN'L PRESET/BAND PRESET/TUNING
VOLUME
TIMER HOUR MIN
INPUT
BALANCE
L R
MIN MAX
Flashes
5
To set the minute setting ahead, press MIN
repeatedly. To set the minute setting
backward, press MIN repeatedly while
holding down PRESET/BAND.
6
Press TIME ADJ once again to confirm the
clock setting.
"Adjusted" appears in the front panel display for a
few seconds, and then the clock appears.
y
You can switch between 12-hour (AM/PM) format and 24-hour
format by pressing HOUR or MIN while the clock is displayed in
the front panel display.
Flashes