Chauvin Arnoux PEL 106 Guia De Inicio Rapido página 6

INSTALLATION OF THE COLOUR-CODED IDENTIFIERS
For polyphase measurements, mark the current sensors, the voltage leads, and the terminals using the coloured rings
and inserts provided with the instrument, assigning one colour to each terminal.
Detach the appropriate inserts and place them in the holes above the terminals (the large ones for the current
„
terminals, the small ones for the voltage terminals).
Clip a ring of the same colour onto each end of the lead that will be connected to the terminal.
„
IN
VN V3
INDICATORS
Indicators
Green indicator: Mains
Indicator lit: the instrument is connected to mains by the external power supply (optional mains power unit).
Indicator off: the instrument is powered by the battery or by the voltage inputs.
Orange/red indicator: Battery
When the instrument is connected to mains, the battery is charged.
Indicator off: battery fully charged.
Indicator blinking orange: battery charging.
Indicator blinking red twice a second: battery low (and no mains power).
Red indicator: Phase order
Indicator off: phase order OK.
Indicator blinking once a second: phase order incorrect.
Red indicator: Overshoot of the measurement range
Indicator off: no overshoot on the inputs.
OL
Indicator blinking once a second: at least one input is outside range limits.
Indicator lit: a lead is missing or is connected to the wrong terminal.
Red/green indicator: SD card
Indicator lit green: the SD card is OK.
Indicator lit red: SD card missing or locked.
Indicator blinking red: SD card being reset.
Indicator blinking alternately red and green: SD card full.
Indicator blinking red once every 5s: the SD card will be full before the recording in progress ends.
Green indicator: 3G-UMTS/GPRS
LED off: 3G-UMTS/GPRS link off (disabled)
LED on: 3G-UMTS/GPRS link enabled but not transmitting
LED blinking twice a second: 3G-UMTS/GPRS link enabled and transmitting
I3 I2 I1
V2 V1
VE/GND
Colour and function