Name Of Parts - Olympus PPO-E04 Manual De Instrucciones

1

Name of Parts

PPO-E04 main body
Silicon O-ring (POL-E101)
Front cap
Rear cap
Lens hood
Grease for silicone O-ring
Pick for O-ring removal
Lens hood clamping screws (x 4)
Clamping screw securing wrench
2 Mounting the PPO-E04 on the Underwater Case
This chapter describes how to mount this product and an applicable lens on the PT-E series Underwater
Case. Before mounting, make sure that no foreign matter is attached to the PPO-E04's O-ring and thread-
ed section or to the case's port mount thread and O-ring contact surface. Apply a thin layer of the provided
silicone O-ring grease to each of these parts.
1) When using the ZUIKO DIGITAL ED 8mm Fisheye lens
Silicone grease application surfaces
Threaded
section
O-ring
O-ring contact surfaces
Align the threaded section of the PPO-E04 with the port mount thread on the PT-E series case.
Hold the PT-E series case firmly with one hand, hold the lens hood around the lens of the PPO-E04 with
your other hand and screw it into the PT-E series by turning the PPO-E04 clockwise.
Resistance increases as the PPO-E04 is screwed in more deeply. However, be sure to screw it in all the way
until there is no gap visible between the case's port mount thread and the PPO-E04's threaded section. If the
resistance is extremely high, apply some more silicone O-ring grease again to surfaces listed above.
ort mount thread
E-2
crew in until
there is no gap.