Installing The Speakers On Wall/Ceiling Brackets Or Speaker Stands (Nx-E440); Placing The Speaker (Nx-C440); Placing The Subwoofer (Sw-P440) - Yamaha NS-P440 Manual De Instrucciones

Installing the speakers on wall/
ceiling brackets or speaker stands
(NX-E440)
You can also use the screw holes on the rear panel or the
bottom of the speakers to install the speakers on
commercially available wall/ceiling brackets or speaker
stands (if you do not use the attached mounting brackets).
■ Using commercially available wall/
ceiling brackets
A screw with a diameter of
6 mm can be used.
(Hole depth: 15 mm)
■ Using commercially available speaker
stands
A screw with a diameter of
4 mm can be used.
(Hole depth: 9 mm)
60 mm
Bottom view
*
The YAMAHA speaker stand SPS-30MMS may not be
available in some areas.

Placing the speaker (NX-C440)

When placing the speaker on top of the TV rack, etc., attach the
provided fasteners at two points on the bottom of the speaker and
on the top of the TV.
Notes
• Do not place the center speaker on top of a TV whose area is
smaller than the bottom of the speaker. If placed, the speaker
may fall and cause injury.
• Do not place the center speaker on top of a TV if the top is
inclined.
• Do not touch the adhesive surface after peeling off the seal as
this will waken its adhesive strength.
• Thoroughly wipe clean the surface where the fastener is to be
applied. Note that adhesive strength is weakened if the surface
is dirty, oily or wet and that this may cause the center speaker to
fall.

Placing the subwoofer (SW-P440)

It is recommended to place the subwoofer on the outside
60 mm
of either the right or the left front speaker (figure A). The
placement shown in figure B is also possible, however, if
Rear view
the subwoofer is placed directly facing the wall, the bass
sound may lessen because the sound from the subwoofer
and the sound reflected by the wall may cancel out each
other. To prevent this from happening, face the subwoofer
obliquely to the wall.
YAMAHA
Speaker stand
SPS-30MMS
(example)
■ Use the non-skid pads
Put the provided non-skid pads at the four corners on the
bottom of the subwoofer to prevent the subwoofer from
moving by vibrations, etc.
SETTING UP THE SPEAKERS
Figure A
( : Subwoofer, : Front speakers)
Peel off
the seal
Peel off
the seal
Figure B
5